Axle Balance Tandem hole rules by state Virginia

Virginia tandem hole rules: 41 ft kingpin to rear axle

For a 53 ft van, reefer or flatbed with a sliding tandem · Checked October 2026

Limit Virginia limits the distance from the kingpin to the center of the rear tandem to 41 ft.

Where it applies: 53 ft trailers on Interstates, designated, primary and secondary highways (some roads may prohibit them). Measured to the rearmost axle or the tandem midpoint.

How to read it

Measure from the kingpin to the point halfway between the two trailer axles.

Source

Virginia Register. Rules checked October 2026. Laws and enforcement change, so confirm with the state before you rely on this.

Set it in the app

In Axle Balance, open State rules and tap Virginia, or plan a route through it. Pro shows which tandem holes are legal for your trailer and warns you before a slide would put you over a state's limit. New to sliding? Read how to slide tandems.

‹ VermontAll statesWashington ›

Other states

AlabamaAlaskaArizonaArkansasCaliforniaColoradoConnecticutDelawareDistrict of ColumbiaFloridaGeorgiaHawaiiIdahoIllinoisIndianaIowaKansasKentuckyLouisianaMaineMarylandMassachusettsMichiganMinnesotaMississippiMissouriMontanaNebraskaNevadaNew HampshireNew JerseyNew MexicoNew YorkNorth CarolinaNorth DakotaOhioOklahomaOregonPennsylvaniaRhode IslandSouth CarolinaSouth DakotaTennesseeTexasUtahVermontVirginiaWashingtonWest VirginiaWisconsinWyoming

Know which way to slide before you get back on the scale. Axle Balance is a free calculator made by a trucker. Enter your scale ticket and it tells you which way to slide your tandems and how many holes, plus your fifth wheel. Works offline in the cab.

Open the free calculator

Estimates and general information only, not legal advice. Laws change and enforcement varies. Always confirm on a certified scale and with the state before you rely on it. See the Terms of Use.

© 2026 Gourdneck Valley Woodworking LLC. All rights reserved. Axle Balance™